BUS2INT

BUS2_INT -- Bus Collision 2

Uses PIR4,BCL2IF, PIE4,BCL2IE Registers and Control Bits.
DT's Interrupts MUST be used with PicBasic Pro and MPASM.

The following block of instructions will establish the interrupt used and the PBP label (your ISR) to jump to once interrupt occurs. Remember; all PBP labels or variables used inside ASM code blocks must be preceded by the underscore,( _GetData). All instruction to the interrupt processor should be in ASM and preceded by the @ symbol and to the far left column of the editor if not included in other ASM code blocks.
Example:
@ INT_DISABLE BUS2_INT

ASM

 INT_LIST     macro     ;IntSource      Label,    Type,    ResetFlag?
            INT_Handler  BUS2_INT     _GetData   PBP       Yes
            endm
            INT_CREAT              ;Creates the interrupt processor
            INT_ENABLE    BUS2_INT  ;enables BUS2 interrupts

ENDASM

INT_ENABLE BUS2_INT – enable BUS2 interrupt.
INT_DISABLE BUS2_INT – disable BUS2 interrupt.
INT_CLEAR BUS2_INT – clear flags
INT_RETURN ---------- To restore and return to the program where interrupt was made.

<< BUS1_INT | 14-bit sources | CCP1_INT >>