INTINT

INT_INT -- INT External Interrupt

Used for external edge triggered interrupts such as RB0.
Uses INTCON,INTF, INTE Registers and Control Bits.

DT's Interrupts MUST be used with PicBasic Pro and MPASM.

The following block of instructions will establish the interrupt used and the PBP label (your ISR) to jump to once interrupt occurs. Remember; all PBP labels or variables used inside ASM code blocks must be preceded by the underscore,( _ToggleLED1). All instruction to the interrupt processor should be in ASM and preceded by the @ symbol and to the far left column of the editor if not included in other ASM code blocks.
Example:
@ INT_DISABLE INT_INT

ASM

 INT_LIST     macro     ;IntSource      Label,    Type,    ResetFlag?
            INT_Handler   INT_INT    _ToggleLED1   PBP       Yes
            endm
            INT_CREAT              ; Creates the interrupt processor
            INT_ENABLE    INT_INT  ;enables external (INT) interrupts

ENDASM

Command functions:
INT_CREATE ;Creates the interrupt processor
INT_ENABLE INT_INT – to enable INT interrupt after handler is created.
INT_DISABLE INT_INT – disable INT interrupt.
INT_CLEAR INT_INT -- clear flags
INT_RETURN -- To restore and return to the program where interrupt was made.

Check your Datasheet for IOCB or other registers that need to be addressed before implementing DT_INT's.

Rising Edge: OPTION_REG.6 = 1
Falling Edge: OPTION_REG.6 = 0


Here's a simple example of toggling an LED using the external interrupt (INT).

INCLUDE "DT_INTS-14.bas"     ; Base Interrupt System
INCLUDE "ReEnterPBP.bas"     ; Include if using PBP interrupts

LED1   VAR  PORTB.1

ASM
INT_LIST  macro    ; IntSource,        Label,  Type, ResetFlag?
        INT_Handler    INT_INT,  _ToggleLED1,   PBP,  yes
    endm
    INT_CREATE               ; Creates the interrupt processor
ENDASM

@   INT_ENABLE   INT_INT     ; enable external (INT) interrupts

Main:
  PAUSE 1
GOTO Main

'---[INT - interrupt handler]---------------------------------------------------
ToggleLED1:
     TOGGLE LED1
@ INT_RETURN



Rising Edge: OPTION_REG.6 = 1

By default, the INT input will generate an interrupt on the Rising edge of the signal.

Using the circuit shown to the right, the LED will toggle on and off with each "Press" of the pushbutton (S1).

The INT input can also be configured to interrupt on the Falling edge by changing the INTEDG bit. (OPTION_REG.6)

    INTEDG: Interrupt Edge Select bit
    1 = Interrupt on rising edge of INT pin
    0 = Interrupt on falling edge of INT pin

If you use this circuit with the Falling edge selected, then the LED will toggle on each button "Release".




Falling Edge: OPTION_REG.6 = 0

Usually it's not a good idea to allow the power supply voltage to leave the PC board. So, this circuit is preferred if using pushbuttons.

With INTEDG = 0, the LED will toggle with each button "Press". Or, with INTEDG = 1, it will toggle with each "Release"








<< | 14-bit sources | RAC_INT >>

Page last modified on March 23, 2018, at 12:23 AM