SSPINT

SSP_INT -- Master Synchronous Serial Port

Uses PIR1,SSP1IF, PIE1,SSP1IE Registers and Control Bits.
DT's Interrupts MUST be used with PicBasic Pro and MPASM.


The following block of instructions will establish the interrupt used and the PBP label (your ISR) to jump to once interrupt occurs. Remember; all PBP labels or variables used inside ASM code blocks must be preceded by the underscore,( _GetData). All instruction to the interrupt processor should be in ASM and preceded by the @ symbol and to the far left column of the editor if not included in other ASM code blocks.
Example:
@ INT_DISABLE SSP_INT

ASM

 INT_LIST     macro     ;IntSource      Label,    Type,    ResetFlag?
            INT_Handler  SSP_INT     _GetData   PBP       Yes
            endm
            INT_CREAT              ;Creates the interrupt processor
            INT_ENABLE    SSP_INT  ;enables SSP interrupts

ENDASM

Command functions:
INT_CREATE ;Creates the interrupt processor
INT_ENABLE SSP_INT enable SSP interrupt.
INT_DISABLE SSP_INT disable SSP interrupt.
INT_CLEAR SSP_INT clear flags
INT_RETURN ---------- To restore and return to the program where interrupt was made.


<< PSP_INT | 14-bit sources | SSP1_INT >>

Page last modified on March 16, 2018, at 11:10 PM